Luigi Pizzolito's Logo

BRZHifi MA12070 Amp Mod

Contents

After a long time yearning for bookshelf/studio speakers, but not having the room or budget for a full-size set. I was quite intrigued by these miniature 2" driver + 2.5" passive radiator bookshelf speakers offered by BRZ HiFi.

For only CNY225 they include both speakers and a MA12070 D-Class speaker amp capable of 2x 80W output. I’m not a fan of the yellow plastic on the frames of the passive radiators, but otherwise I love their aesthetic and their adorable 90x85x138mm size. One review described them as “The poor man’s Rolls-Royce of bookshelf speakers.”, and I was excited to try them out.

Original MA12070 Amplifier

Opening up the small class-D amp, we see; the expected MA12070 chip circuit, an op-amp based single-ended to differential converter frontend, and a power soft-start circuit.

Disappointingly though, the input decoupling caps are no-name brand film capacitors, instead of the high-quality WIMA capacitors promised in the product listing. Additionally, all of the decoupling capacitor’s in the later audio stages are low-cost ceramic capacitors. Which exhibit a non-ideal distortion when used for decoupling in audio circuits, due to voltage saturation which drops the capacitance if there is a DC bias across it.

Modifications

The first order of business was replacing those first AC coupling capacitors with real WIMA brand ones:

Next, I decided to search online for any other possible modifications that people have done to improve this amplifier unit. My first impressions of using this unit were not bad, although the bass and lower frequencies were quieter than desired.

This is when I stumbled upon this post on the diyAudio forums. Where theAnonymous1 noticed that the single-ended to differential op-amp front end had the inverting and non-inverting op-amps with their inputs in parallel; lowering the input impedance more than necessary. I followed his modification instructions to switch that so that they are chained in series. As well as adding my own modifications on top; larger electrolytic capacitors for power decoupling for the 2 op-amps and the step-down buck converter, and a 100nF metal-film decoupling capacitor right at the DC jack power input.

Last but not least, I replaced all four 2.2uF decoupling capacitors at the differential input pins of the MA12070 amplifier chip with WIMA film capacitors as well instead of ceramic. While I was at it, I also replaced the output filter capacitor with the equivalent WIMA film capacitors.

After closing up the unit, I had a nice and much better sounding class-D amp on my desk. Just by changing the AC coupling caps the low-end improved by a small amount. I will eventually build a full EQ for this to really get the most out of these cool little bookshelf speakers.

Speaker Stands

The speakers themselves did not come with any sort of stand, just foam feet. Alas, I do not have a bookshelf over my desk, so I designed up some speaker stands in Fusion360 to 3D print:

Great care was taken to ensure the optimum angles for the speakers when I am sitting down at my desk. Both in terms of the vertical inclination and how I should rotate them to obtain a good stereo image. I 3D printed these stands in black PLA using gyroid infill, this way I could later fill the bases with some 2 part resin to add some weight. As well as some sanding, black spray paint and transparent coating for a nice surface finish, and adding an adhesive rubber pad to both of the base plates so they don’t get moved accidentally.

There we have it, with these little modifications the deal for these low-cost speakers became even better. And with these speaker stands, I finally have a proper setup.

Categories
Tags