LED Tester
This is an old cross-post from Instructables, see the original here.
Are you tired of having to change the resistor every time you change the voltage to power your LED??
Here is your solution! a constant current source. Built with only two transistors, fits in a 3 by 5 perfboard.
Step 1: Materials
You are going to need:
- NPN Transistors (2)
- 1kΩ Resistor (1)
- 220Ω Resistor (1)
- 9v Battery Snap / Power (1)
- LED / Header (1)
- Breadboard / Perboard (1)
Step 2: Schematic / Plan
This is the circuit diagram, very simple only two transistors.
Step 3: Assembly
Step 4: Apply Power
Plug in your power wires/battery snap and you get 10-20ma.
Step 5: Done
Now you have a 20mA led tester. Run it off USB, car battery, 9V it will light your leds!
Categories
Tags
